當前位置：首頁 »新聞中心 » 公司新聞自上料攪拌車的優勢及其操作注意事項

自上料攪拌車的優勢及其操作注意事項

來源：http://www.bflrsn.cn 瀏覽：0發表時間：2022-09-23

隨著時代的發展，生產越來越機械化，智能化，自上料攪拌車的使用為更多人所接受，下面自上料攪拌車廠家就來講講該設備的使用優勢以及操作的注意事項。

With the development of the times, the production is becoming more mechanized and intelligent, and the use of self feeding mixer is accepted by more people. The following is the introduction of the advantages of the equipment and the precautions for operation from the manufacturer of the charging mixer.

自上料攪拌車的優勢：

Advantages of self feeding mixer:

1、具有裝載、攪拌和運輸三種功能

1. It has three functions of loading, mixing and transportation

自上料攪拌車把裝載機、混凝土攪拌車和運輸車這三種機械整合到了一起，所以同時擁有三個功能，自己就能完成裝載、攪拌和運輸這三個步驟，所以工作效率比起傳統的混凝土攪拌車高了不少。

The self loading mixer integrates the loader, concrete mixer and transport vehicle, so it has three functions at the same time. It can complete the three steps of loading, mixing and transportation by itself, so its work efficiency is much higher than that of the traditional concrete mixer.

2、拌合的水泥質量穩定

2. The quality of mixed cement is stable

由于自上料攪拌車的自動化程度比較高，所以拌合出來的水泥標號能夠得到保證，穩定性也更好。

Due to the high degree of automation of the self loading mixer, the cement grade can be guaranteed and the stability is better.

3、適用場合多

3. Many applications

由于自上料攪拌車自帶水箱和水泵，所以只要在有水的地方就能抽水，適用的場合更多。

Since the self feeding mixer has its own water tank and water pump, it can pump water wherever there is water, which is applicable to more occasions.

4、操作簡單，節省人力

4. Simple operation and manpower saving

由于自上料攪拌車自動化程度更高，所以操作起來比較簡單，通常只需要兩個人就可以工作，其他人只需要做一些輔助工作，這樣就節省了不少的人力。

Since the self feeding mixer has a higher degree of automation, it is relatively simple to operate. Usually only two people can work, and others only need to do some auxiliary work, which saves a lot of manpower.

自上料攪拌車的操作注意事項：

Precautions for operation of self feeding mixer truck:

一、自動上料攪拌車應停在平地上，并將鏟斗平放在地面上。當發動機熄火后，需反復多次扳動工作裝置操縱手柄，確保各液壓缸處于無壓休息狀態。如果自動上料攪拌車只能停在坡道上時，要將輪胎墊牢。

1、 The automatic feeding mixer shall be parked on the flat ground, and the bucket shall be placed on the ground. When the engine is off, pull the operating handle of the working device repeatedly to ensure that each hydraulic cylinder is in a pressure free rest state. If the automatic feeding mixer can only stop on the ramp, the tire shall be firmly padded.

二、自上料攪拌車裝料前，應先排凈攪拌罐內殘存的積水和雜物。在運輸過程中要不停的轉動，以防混凝土離析。自上料攪拌車到達工地和卸料之前，應先使攪拌罐以每分鐘14—18轉的速度轉1—2分鐘，然后再進行反轉卸料。反轉之前，應使攪拌罐停穩不轉。

2、 Before loading from the charging mixer truck, the remaining water and sundries in the mixing tank shall be drained. Keep rotating during transportation to prevent concrete segregation. Before the loading mixer truck arrives at the construction site and discharges materials, the mixing tank shall be rotated for 1-2 minutes at the speed of 14-18 revolutions per minute, and then the reverse unloading shall be carried out. Before reversing, the mixing tank shall be stopped stably.
自上料攪拌車廠家

三、環境溫度如果高于25攝氏度，從裝料、運輸、到卸料的延續時間不得超過60分鐘；如果環境溫度低于25攝氏度，上述時間不得超過90分鐘。

3、 If the ambient temperature is higher than 25 ℃, the duration from loading, transportation to unloading shall not exceed 60 minutes; If the ambient temperature is below 25 ℃, the above time shall not exceed 90 minutes.

四、在施工現場卸料完畢后，應立即用自上料攪拌車隨車帶的軟管沖洗進料斗、出料斗、卸料溜槽等處，清除粘附在車身各處的污泥及混凝土。在返回?cái)嚢枵镜耐局校瑧?yīng)向攪拌罐內注150L—200L的水來清洗攪拌罐壁及葉片粘結的混凝土殘?jiān)?/div>

4、 After unloading at the construction site, the hose attached to the truck from the loading mixer shall be used to flush the feed hopper, discharge hopper, discharge chute, etc., to remove the sludge and concrete adhering to the vehicle body. On the way back to the mixing plant, 150L - 200L water shall be injected into the mixing tank to clean the concrete residue bonded by the mixing tank wall and blades.

五、每天工作結束后，司機應負責向攪拌罐內注入清水并以每分鐘14—18轉的速度旋轉5—10分鐘，然后將水排去，以保障攪拌罐內清潔。用高壓水清洗攪拌罐各個部分時，應注意避開儀表及操縱桿等部位。

5、 At the end of each day's work, the driver shall be responsible for injecting clean water into the mixing tank and rotating it for 5-10 minutes at the speed of 14-18 revolutions per minute, and then draining the water to ensure the cleanness of the mixing tank. When cleaning all parts of the mixing tank with high-pressure water, avoid instruments, control rods and other parts.

此外要注意，自上料攪拌車工作時，不得將手伸入旋轉的攪拌罐內，嚴禁將手伸入主卸料溜槽和加長卸料溜槽的連接部位，以免發生事故。更多相關內容就來我們網站http://www.bflrsn.cn咨詢吧！

In addition, it should be noted that when the self loading mixer is working, it is not allowed to put your hand into the rotating mixing tank, and it is not allowed to put your hand into the connection part of the main discharge chute and the extended discharge chute, so as to avoid accidents. More relevant content will come to our website http://www.bflrsn.cn Consult!

下一篇：攪拌車在預拌混凝土方面的正常操作上一篇：自上料攪拌車有哪些常見故障要知道的